Nortel bsr222 vpn setup

You might also want to read these other posts Wonder what is the official position about the site owner about using the forum for sharing Nortel Software. Have you enabled the SSH server? Hi Michael McNamara! If you open the case of Contivity you can unplug CF and make it image useing cardreader and any kind of unix system dd. Thanks for answer. I try to find another way of reanimation this damn router. Or Duzerz will help me. I wrote the letter to him. Hi Alexey! Have you any CF image from 1xxx device?

I have problems with CF on my Contivity I have enabled the SSH server and permitted it on both the public and private interfaces. It refuses SSH connections on both interfaces. Is there anything else i can try? You should be trying to connect to the management IP interface, not the routing IP interface. I will assume that you are using the correct IP address.

Are you running the firewall on either interface? The firewall is enabled for the public interface, with rules doing port mapping and port forwarding. Is there anything I can do about it? I had 50 logins configured with 2 or 3 simultaneous PPTP clients not being able to connect. Any other idea that I can try out? Iam facing a strange issue with Nortel VPN router ,Observed from LAN 0 interface statistics, IP Local system filter drops are increasing frequently not sure why it is increasing,Can you please help me out,Please find the below details.

Those stats are probably indicators of your interface filters dropping packets. Is this the public or private interface? If things are working fine you can probably ignore the statistic. If this is your private interface you could be dropping packets internally. Again you should look at the interface level and see what filter you have defined. That was very good write up…thumbs up! The end goal of this branch-to-branch tunnel is to pass a video stream; an encoder at one end, and a decoder at the other.

These devices must be on the same subnet ie, Your going to need to build a tunnel IPSec, L2TP, etc and then bridge across that tunnel as opposed to route across the tunnel. Hi Mike, I have a contivity at the main office and now I can connect with a vpn connection, the problem that I have is , when I connected from my home I can not navigate for internet.

Any idea? Is that IP address able to access the Internet from your office location? By default all traffic will be routed across the IPSec tunnel back to your Nortel VPN router and placed onto your internal network. If you only want traffic for your internal network to route across the IPSec tunnel you need to look into setting up Split-Tunneling within the Nortel That configuration would then route traffic for your internal network, say I disabled pretty much any routing protocol, but Natting since traffic needs to go out to the internet.

I pretty much ran out of ideas, here. I need to stop inter-vlan traffic somehow. I got the following entries in the routing table:. If you think about it the VPN router is acting just like a typical router, you need to create some filters to drop packets to the other networks.

Michael, I guess help will be very welcome. I have 2 sub-interfaces: Int: I placed a filter restriction on the main interface to block icmp traffic going to the ip Same results when i set the filter either incoming or outgoing. Am I assuming the use of the interface filters wrong?? You may also need to build an allow all rule at the bottom of the filter rules.

Man, right on the money! Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action. Click Here to join Tek-Tips and talk with other members! Already a Member? Join your peers on the Internet's largest technical computer professional community. It's easy to join and it's free. Register now while it's still free! Already a member? Close this window and log in.

Join Us Close. Join Tek-Tips Forums! Join Us! By joining you are opting in to receive e-mail. Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Visit Site. Developer's Description By Nortel Networks. Full Specifications. What's new in version Release June 9, Date Added June 9, Version Operating Systems. Additional Requirements None. Total Downloads 96, Downloads Last Week Report Software. Related Software.

TeamViewer Free to try. Establish instantly comprehensive, permanent, real-time remote access, control, and support through secure global network. AnyDesk Free. Access all your programs, documents, and files from anywhere without using a cloud service.